Table of Contents
Advertisement
4. Remove the USB flash drive.
5. Select OK to confirm the removal of the USB flash drive.
Exporting Raw Data
Export kinetic data for the selected test results from the Results screen.
To export raw data:
1. From the Results screen, select the row(s) of the desired result(s).
The Export Raw Data button becomes enabled.
2. Select Export Raw Data.
The Raw Data Export window opens.
The Output Directory field lists one of the following locations:
The network destination selected on the Data Export Management
l
menu of the System Configuration screen (see Raw Data Export
Directory on page 230).
The USB drive location (E:\) if a USB disk is installed.
l
3. Select the file directory button
OK, if necessary.
A directory opens to allow for changes to the desired file destination.
4. Select OK.
The system exports the kinetic data to the chosen export file location.
The default name of the raw data file follows the naming convention:
RawData-<Raw Data Export Time>-LUMI.csv
For example, a report that was exported on February 23, 2012, at 11:30:26
AM would be named:
RawData-20120223-11.30.26-LUMI.pdf
Exporting LIS Data
Export LIS data for the selected test results from the Results screen. If the
Enable Result Verification configuration is enabled, LIS results cannot be
exported until they have been verified (see Enable Result Verification on page
227).
®
Panther System
Operator's Manual
AW-17791-001 Rev. 002 (EN)
Note—If saving to a USB flash drive, wait until the "Update In
Progress" notification clears before removing the USB flash drive to
avoid data corruption (see Removal of a USB Flash Drive on page
156).
, select a new export location, and select
System Operation
157
Advertisement
Table of Contents
