Table of Contents
Advertisement
the bag flat to the sides of the container.
Fold the top of the bag down around the outside of the Solid Waste
l
Container.
10. Slide a new Waste Cover over the Waste Bag on the back of the container.
11. Inspect the Liquid Waste Container for cracks and smooth magnet movement. If
cracks are found, contact Hologic Technical Support.
12. Remove the bottle cap from the Liquid Waste Container and slowly pour the
contents of the Liquid Waste Container into the appropriate designated sink or
receptacle. Dispose of the contents according to laboratory policies.
Warning—Tilt the Liquid Waste Container appropriately to ensure that
no waste enters the tubing within the container. Use the holds on the
container to aide in pouring of the contents.
Figure 107. Disposing of Liquid Waste Container Contents (Example)
13. Add approximately 2 L of 2.5%–3.5% sodium hypochlorite solution and then re-
cap the container.
14. Swirl the solution in the container to make sure the sodium hypochlorite solution
contacts the inner surfaces of the container. Do not invert container.
15. Allow the solution to remain in the container for at least 10 minutes and then
remove the cap and dispose of the rinse solution according to laboratory policies.
16. Add approximately 2 L of water and then re-cap the container.
®
Panther System
Operator's Manual
AW-17791-001 Rev. 002 (EN)
Maintenance
208
Advertisement
Table of Contents
