Altering Replicate Count For Sample Defaults; Figure 61. Sample Defaults Window (Example) - Hologic Panther System Operator's Manual

The Sample Defaults window opens with current default assay types and test
replicate settings.
2. From the Sample Defaults window, select Add.
A Select Default Assays window opens with a display of all available assays.
3. Select the desired assay(s) to add assay test orders to the sample defaults.
Select more than one assay type if needed.
4. If an assay has multiple analytes, select the analytes to be tested, if necessary, by
selecting Select Analytes. If not changing the analyte selection, skip to step 7.
An Analyte Selection window opens.
Note—Use the Select Analytes functionality to select a single analyte
test order from assays with multiple targets, if necessary. Remove the
total RLU for the analyte that is not selected (suppressed) by enabling
the Enable RLU value suppression for Aptima Combo 2
configuration (see Results Management on page 227).
5. Add or delete analytes as appropriate by selecting Add or X for the analytes
available on the screen.
6. Select OK to accept the chosen analytes.
The Analyte Selection window closes.
7. Select OK to accept the chosen test order configuration.
The Select Default Assays window closes. The Sample Defaults window
remains on display after completion of this task.
8. To continue with sample default setup, select another button on the window or
select Accept to accept all changes and exit to the Sample Rack Bay screen.

Altering Replicate Count for Sample Defaults

To alter the number of replicates tested for each of the selected default assays:
1. From the Sample Defaults panel of the Sample Rack Bay screen, select Set.
®
Panther System Operator's Manual
AW-17791-001 Rev. 002 (EN)

Figure 61. Sample Defaults Window (Example)

System Operation
118