Table of Contents
Advertisement
LIS Configuration
Use the LIS Configuration screen to configure LIS settings. Only an administrator can
alter the LIS configuration settings (see Adding Operator Accounts on page 240). Refer to
the Panther System LIS Host interface Guide for assistance in configuring and
troubleshooting the LIS connection and settings.
Select Save on the LIS Configuration screen after altering LIS configurations. The
following LIS settings can be configured from the LIS Configuration screen (see LIS
Configuration Screen on page 80):
Table 110. LIS Configuration Options
General Settings
Enable LIS Connections
l
Interface Layer
l
Instrument ID
l
Host ID
l
Enable Unidirectional Mode
l
Enable Automatic Test Order Query
l
Enable Automatic Test Order Query in Compressed
l
Format
Enable Host Query Responding
l
Enable Result Flag Sending in Compressed Format
l
Enable Calibration Result Sending
l
Enable Control Result Sending
l
Enable External Quality Control Sending
l
Enable Automatic Result Sending
l
Enable Automatic Result Holding
l
Field Delimiter
l
Component Delimiter
l
Repeat Delimiter
l
Escape Delimiter
l
Enable Escaping
l
®
Panther System
Operator's Manual
AW-17791-001 Rev. 002 (EN)
System Administration
236
Advertisement
Table of Contents
