Table of Contents
Advertisement
Select and configure the following option within the menu:
Table 108. UPS Management Setting Options
Option
Enable UPS
Shutdown
Once the Enable UPS Shutdown setting is enabled, the UPS icon appears in the Status
Panel. The icon can appear in the following two states:
Icon not flashing—UPS connected
l
Icon flashing—UPS connection not detected
l
The operator can also select the UPS icon for additional status information. Available
status messages include the following:
No UPS found
l
Power Source: AC (Battery Charge x%)
l
Power source: Battery (Battery Charge x%)
l
Printer Management
Use the Printer Management expansion menu to configure the printer settings as
needed. Contact Hologic personnel to assist with networking the printer.
Select and configure the following option within the menu:
Table 109. Printer Settings Options
Option
Default Printer
Name
Default Printer Name
To select the printer to use with the system:
1. From the expanded Printer Settings menu on the System Configuration screen, select
the Default Printer Name field.
A Default Printer Selection window opens.
2. From the window, select the printer to use with the Panther System.
3. Select OK when finished.
®
Panther System
Operator's Manual
AW-17791-001 Rev. 002 (EN)
Description
Select this cell to enable automatic shutdown of the system
following an extended loss of power.
Description
Select this field to adjust the name for the printer to be used with
the system.
Additional instructions provided below.
System Administration
235
Advertisement
Table of Contents
