Table of Contents
Advertisement
2. Select Send results to LIS.
Export Viral Data
Note—This feature is not available in all system software configurations.
Export raw results data for select real-time assays from the Results screen. The
Export Viral Data button will not be enabled if any non real-time assay results are
selected.
To export raw real-time assay results data:
1. From the Results screen, select the row(s) of the desired result(s).
2. Select Export Viral Data.
The Viral Intermediate Export window opens.
The Output Directory field lists one of the following locations.
The network destination selected on the Data Export Management menu of
l
the System Configuration screen (see Data Export Management on page
230).
The USB drive location (E:\) if a USB disk is installed.
l
3. If the export location needs to be changed:
a. Select the file directory button (
A directory opens to allow for changes to the desired file destination.
b. Select a new export location and select OK.
4. Select OK.
The system exports the kinetic data to the chosen export file location. The
default name of the viral data file follows the naming convention:
@VLI<Instrument Serial Number>-<Time Worklist Initiated>-<Worklist ID>.csv
For example, worklist 000350-20120223-01 that was initiated on February 23,
2012, at 11:30:26 AM on instrument 00350 would be named:
@VLI00350-20120223-113026-000148000350-20120223-01.csv
Note—If saving to a USB flash drive, wait until the "Update In Progress"
notification clears before removing the USB flash drive to avoid data
corruption (see Removal of a USB Flash Drive on page 156).
Reports Management
This section contains descriptions on how to create reports from the functionality on the
Report Menu screen. Use the filters for each of the available report types to generate a
report that contains the needed information.
®
Panther System
Operator's Manual
AW-17791-001 Rev. 002 (EN)
System Operation
).
159
Advertisement
Table of Contents
