Sending Results To Lis - Hologic Panther System Operator's Manual

To export LIS data:
1. From the Results screen, select the row(s) of the desired sample result(s).
The Export LIS Data button becomes enabled.
2. Select Export LIS Data.
The LIS Data Export window opens.
The Output directory field lists one of the following locations:
The network destination selected on the Data Export Management
l
menu of the System Configuration screen (see Data Export
Management on page 230).
The USB drive location (E:\) if a USB disk is installed.
l
3. Select the field directory button
select OK, if necessary.
A directory opens to allow for changes to the desired file destination.
4. Select OK.
The system exports the LIS data to the chosen export file location.
The default name of the LIS data file follows the naming convention:
@Pt2<Instrument Serial Number>-<Time Worklist Initiated>-<Worklist
ID>.lis
For example, worklist 000350-20120223-01 that was initiated on February
23, 2012, at 11:30:26 AM on instrument 00350 would be named:
@Pt200350-20120223-113026-000148000350-20120223-01.lis

Sending Results to LIS

If the LIS configuration Enable Automatic Results Sending is not enabled,
manually send the selected test results to the LIS from the Results screen (see
Results Screen on page 73).
If the Enable Result Verification configuration is enabled, verify the results before
sending (see Enable Result Verification on page 227).
To send data to the LIS:
1. From the Results screen, select the row(s) of the desired result(s). Ensure results
are verified prior to sending if needed (see Verifying Results on page 155).
The Send results to LIS button will be enabled.
®
Panther System Operator's Manual
AW-17791-001 Rev. 002 (EN)
Note—If saving to a USB flash drive, wait until the "Update In
Progress" notification clears before removing the USB flash drive to
avoid data corruption (see Removal of a USB Flash Drive on page
156).
, select a new export location, and
System Operation
158