Installing The New Wi-Fi / Ant+ Console On The New Group Cycle; (D92); Console Downgrade: Assembly Of The Old Wi-Fi Console On The New Group Cycle (D92) With The New Wi-Fi / Ant+ Console Installed; Software Upgrade For The New Wi-Fi / Ant+ Console - Technogym Group Cycle D92 Technical Service Manual

1), the technician must:
- Check the version of the WATT SENSOR TONIC from the terminal using the
@LOWKITFWVER command;
- If the version is older than 2.4: proceed with upgrading the FW using the Equipment
Software Loader.
14.1.3.2 INSTALLING THE NEW WI-FI / ANT+ CONSOLE ON THE NEW
GROUP CYCLE (D92)
The new console is equipped with projections for fastening on the perforated handlebar with the
provided screws. For details, see the instruction sheet "Group Cycle Console - Assembly Instruc-
tions" provided in the kit.
If the Group Cycle handlebar has velcro, remove the rear cover from the old console and fasten it
to the new console. In this way, the new WI-FI / ANT+ console will be fastened to the Group Cycle
with the velcro.
14.1.4 CONSOLE DOWNGRADE: ASSEMBLY OF THE OLD
WI-FI CONSOLE ON THE NEW GROUP CYCLE (D92)
WITH THE NEW WI-FI / ANT+ CONSOLE INSTALLED
From a technical point of view, it is possible to downgrade from the new WI-FI console to the old
one.
14.1.5 SOFTWARE UPGRADE FOR THE NEW WI-FI / ANT+
CONSOLE
For details see "7.2 software upgrade for the new wi-fi / ant+ console".
14.1.6

COMMANDS FROM THE TERMINAL

For details see "9. Executable SW for diagnostics with PC : TERMINAL".
14.1.7

EQUIPMENT SETUP APP

There is nothing to be configured in the APP to distinguish it from the old WI-FI console
Page 220
New Group Cycle (D92):

Technical Service Guide - Rev. 5.1

Document uncontrolled when printed