Writing The Wep Key Number; Checking Connection Type; Writing The Console Ip Address - Technogym Group Cycle D92 Technical Service Manual

New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
9.2.3.3

WRITING THE WEP KEY NUMBER

Command
Command @SWEPKEYINDEX index#
The parameter index indicates the number of the WEP key utilised (the permitted values are 1, 2, 3
and 4). If a WEP key is not used, enter 0. Only WEP open key mode is supported.
9.2.3.4

CHECKING CONNECTION TYPE

Command
Command @RWIFICONFIG#
The parameter ssid indicates the name of the Wi-Fi network.
9.2.3.5

WRITING THE CONSOLE IP ADDRESS

Command
Command @SIPADDRESS ipaddress#
The parameter ipaddress indicates the static IP address of the console.
Document uncontrolled when printed
Notes
Sets the WEP key used to connect to the access
point with WEP encryption.
Table 39
Displays SSID, password and type of encryption
used by the configured access point.
Table 40
Sets the console's static IP address.
Table 41
Notes
Notes
Page 109