9.2.3.6
WRITING THE GATEWAY ADDRESS
Command
Command @SDEFGATEWAY gateway#
The parameter gateway indicates the value of the IP address of the default gateway.
9.2.3.7
CHECKING THE IP ADDRESS - DEFAULT GATEWAY -
NETMASK
Command
Command @RNETPARAM#
9.2.3.8
READING THE WI-FI POWER
Command
Command @RWIFIRSSI#
The signal must be above -85dBm (e.g. -80dBm = OK).
9.2.4 CONFIGURING UNITY SELF
9.2.4.1
SETTING PARAMETERS
Command
Command @SRTMSOCKET ip_add port#
Page 110
Technical Service Guide - Rev. 5.1
Sets the IP address of the default gateway.
Table 42
Displays the console's IP address, the default
gateway and the netmask the console is current-
ly using (regardless of whether these have been
assigned in DHCP mode or have been config-
ured as static).
Table 43
Shows the Wi-Fi receiving power.
Table 44
Sets the IP address and the UDP port where
UNITY SELF is located.
Document uncontrolled when printed
New Group Cycle (D92):
Notes
Notes
Notes
Notes