Technogym Group Cycle D92 Technical Service Manual page 116

4. Check if the date and time are coherent using the command @GETDATE#. The time should
be a few seconds ahead (time passed between setting the date and time and reading the date
and time).
5. Disconnect the USB - MINI USB cable from the console. Wait 10 seconds. Reconnect the PC
to the console using the USB – MINI USB cable. From the terminal, launch the read date and
time command: @GETDATE#. The date and time must be coherent with what is set. The time
should be a few seconds ahead (time passed between setting the date and time and reading
the date and time).
Page 116
New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
Document uncontrolled when printed