Technogym Group Cycle D92 Technical Service Manual page 96

13a.2- Check if the the network icon appears in the top left corner of the console:
_13b- If the network was already configured but you need to modify it, it's necessary to
use a combo. For details see
14- Then, scan the QR Code label of the Group Cycle console with your smartphone camera.
Configure the Group Cycle console with the number of the bike and the room in the "Equipment
Setting" section of the Technogym Equipment Set-Up App.
The name of the room must correspond to the room created in the pro.mywellness.com site. The name
of the room where UNITY SELF is located must be equal to the name of the room where the Group
Cycles are located.
The assigned numbers must identify univocally the Unity Self and each Group Cycle of the class.
The configured bike number will be the identification projected on the screen during the class man-
aged with UNITY SELF.
Page 96
-if yes keep the display on untill it appears YES on the display, it means that
the net work configuration is done. Please note that the message YES doesn't
indicate that the configuration is correct.
-If the network icon does not appear wait until the console switches off and
repeat this procedure from step 13a.1.
Technical Service Guide - Rev. 5.1
Figure 77
§"8.4 second network configuration".
Document uncontrolled when printed
New Group Cycle (D92):