Technogym Group Cycle D92 Technical Service Manual page 71

New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
1
2
Figure 48
3. To reinstall the plate, fasten the two plate fastening and regulation screws (1) and (2) of the
plate to the Group Cycle. While reinstalling the plate on which the Watt Sensor ID is fixed, turn the
upper regulation screw (1) to correct reinstall the Watt Sensor ID: The distance between the Watt
Sensor ID and the flywheel MUST BE EQUAL to the distance that was taken as a reference.
1
Figure 49
Page 71
Document uncontrolled when printed