Technogym Group Cycle D92 Technical Service Manual page 63

New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
Document uncontrolled when printed
4
3
Figure 36
Figure 37
Figure 38
3. Check that the knob is in a hori-
zontal position (must be the zero
position).
4. If the knob is not in a horizontal
position, move it so it is in this
position. Keep the knob station-
ary with one hand and adjust the
self-locking nut (3) that rests on
the black plastic spacer (4).
5. Place the correct template (5) on
the aluminium disc and check
5
that the magnets on the brake
come into contact with the tem-
plate, as shown in the following
figure.
Page 63