Procedure For Replacing The Watt Sensor Id; Ics - Technogym Group Cycle D92 Technical Service Manual

6.6 PROCEDURE FOR REPLACING THE WATT
SENSOR ID BOARD ON GROUP CYCLES FIT
WITH REV. 2 ELECTRONICS
ATTENTION: If replacing the Watt Sensor ID board, the operation must be performed
without changing the distance between the sensor and the flywheel. Carefully follow the
instructions for replacing the Watt Sensor ID board provided below.
ATTENTION: Do not unscrew the plate fastening and regulation screws (1) and (2) to
prevent changing the distance between the sensor and the flywheel.
1. Remove the guards necessary to reach the cover of the Watt Sensor ID board, located on the left
side of the equipment.
2. Remove the fastening screws (A) that fasten the Watt Sensor ID board cover to the plate.
Page 66
Technical Service Guide - Rev. 5.1
1
2
Figure 42
Document uncontrolled when printed
New Group Cycle (D92):