Technogym Group Cycle D92 Technical Service Manual page 67

New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
3. Remove the screws that fasten the cover to the box. Remove the cover (B).
4. Remove the screws that fasten the Watt Sensor ID board to the box.
5. Disconnect the two cables connected to the Watt Sensor ID board.
6. Replace the Watt Sensor ID board with the new Watt Sensor ID board. ATTENTION: the passage
of the pre-existing cables must be guaranteed. The two cables that exit the cover must cross, as
Document uncontrolled when printed
Figure 43
Figure 44
A
B
Page 67