Setting The Data Send Period; Displaying The Realtime Monitor Configuration; Enabling Data Sending; Disabling Data Sending - Technogym Group Cycle D92 Technical Service Manual

New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
The parameter ip_add indicates the IP address where UNITY SELF is located. The parameter port
indicates the number of the UDP port where UNITY SELF is located.
9.2.4.2

SETTING THE DATA SEND PERIOD

Command
Command @SRTMPOLLING tsend#
The parameter tsend indicates the data sending period to UNITY SELF (expressed in seconds).
9.2.4.3

DISPLAYING THE REALTIME MONITOR CONFIGURATION

Command
Command @RRTMCONFIG#
9.2.4.4

ENABLING DATA SENDING

Command
Command @ENABLERTM#
9.2.4.5

DISABLING DATA SENDING

Command
Command @DISABLERTM#
Document uncontrolled when printed
Table 45
Sets the data send period to UNITY SELF.
Displays the UNITY SELF configuration.
Table 46
Enables sending data to UNITY SELF.
Table 47
Disables sending data to UNITY SELF.
Table 48
Notes
Notes
Notes
Notes
Page 111