Group Cycle Class; Requirements For Configuring Class; Group Cycle Class Configuration - Technogym Group Cycle D92 Technical Service Manual

New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
8.

GROUP CYCLE CLASS

8.1 REQUIREMENTS FOR CONFIGURING CLASS

GROUP CYCLE CLASS: For details, see the Group Cycle and Unity Self Pre-Installation Require-
ments documents available on Technogym Direct.
GROUP CYCLE HR CLASS: For details, see the Group Cycle and Unity Self Pre-Installation Re-
quirements documents available on Technogym Direct. Moreover, see the Teambeats Pre-Instal-
lation Requirements document available on Technogym Direct, since it's necessary to install the
WASP antenna.

8.2 GROUP CYCLE CLASS CONFIGURATION

The Group Cycle Class configuration described below was done using an Android smartphone.
PRE-INSTALLATION REQUIREMENTS:
1-Check that the minimum installation requirements for Group Cycle and Unity Self are respected.
For GROUP CYCLE HR CLASS check also that the Teambeats minimum installation requirements
are respected.
GROUP CYCLE APP:
2-Go to the site pro.mywellness.com. In the Technogym APP Store section, select and install the
Group Cycle application: GROUP CYCLE CLASS or GROUP CYCLE HR CLASS or both.
Normally the App installation on pro.mywellness.com is done by the Cloud technical referent of the
After Sales Office.
The Group Cycle Class can be configured as main App on Unity Self, as detailed at §"8.3 configuring
the group cycle app as the main unity self app".
Document uncontrolled when printed
Page 87