Technogym Group Cycle D92 Technical Service Manual page 164

15
Figure 162
16
13
Figure 163
12
Figure 164
Page 164
14
13
Technical Service Guide - Rev. 5.1
7. Replace the aluminium disc (14) by un-
screwing the screws (15) with a 3 mm Al-
len wrench.
ATTENTION: When refitting the screws
(15), apply Loctite 243 on them and
tighten them with a torque equal to 5
Nm (3.69 lbf-ft).
8. Use a Ø 12 x 95 mm lock pin (16) and po-
sition the spacers (13).
9. Position the transmission belt and - where
applicable - the generator belt, then fit the
flywheel (12) in its seat.
Document uncontrolled when printed
New Group Cycle (D92):