Checking The Alignment Between The Hole And The Tooth Of The Knob - Technogym Group Cycle D92 Technical Service Manual

New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
6.5.1 CHECKING THE ALIGNMENT BETWEEN THE HOLE AND
THE TOOTH OF THE KNOB
1. Remove the lens and the STOP card, turn the knob anti-clockwise to the limit stop and check
the alignment between the hole and the tooth.
Figure 27
If the position is not correct, adjust the self-locking nut (23) as shown below.
Page 57
Document uncontrolled when printed