Program Watt Sensor Board; Write Serial Number; Write Torque Table - Technogym Group Cycle D92 Technical Service Manual

CASE 2: Only the following two commands are active if the database does not contain the data for
this specific equipment:
•

WRITE SERIAL NUMBER;

• DOWNLOAD CALIBRATION FILES: Download the calibration files for the written SN. An in-
ternet connection is required. The information remains stored in the database.
The commands are described in detail below.
10.3.1

PROGRAM WATT SENSOR BOARD

This makes it possible to perform the commands WRITE SERIAL NUMBER and WRITE TORQUE
TABLE in sequence in the Watt Sensor board. For details, see "10.3.2 Write serial number" and

"10.3.3 write torque table".

In case of the Watt Sensor ID board, after launching this command, brake calibration MUST be per-
formed.
10.3.2 WRITE SERIAL NUMBER
This command is used to write the Serial Number in the SW of the Watt Sensor board.
If the command does not function: disconnect the USB cable (identified with the red ring) from the
PC; wait approx. 10 seconds; reconnect the USB cable (identified with the red ring)to the PC.
If the Serial Number is entered correctly, a message appears indicating that the Serial Number was
entered correctly. Otherwise, a Serial Number insertion error message appears: enter the correct
Serial Number.
10.3.3 WRITE TORQUE TABLE
This command is used to automatically write the torque table in the Watt Sensor board.
At this point, the window displaying the progress of the torque table writing appears. Wait for the
loading to finish.
In case of the Watt Sensor ID board, after launching this command, brake calibration MUST be per-
formed.
Page 126
New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
Document uncontrolled when printed