Configuring Date And Time; Rtc Initialisation; Setting The Date And Time - Technogym Group Cycle D92 Technical Service Manual

9.2.5 CONFIGURING DATE AND TIME

9.2.5.1

RTC INITIALISATION

Command
Command @RTCINIT#
9.2.5.2

SETTING THE DATE AND TIME

Command
@SETDATE dd mm yyyy hh mn
Command
ss tz#
The calibration of the RTC is important for the correct functioning of the Cloud services via TLS/
SSL.
Page 112
Technical Service Guide - Rev. 5.1
Initialises the RTC (Real Time Clock).
Table 49
Configures the date and time in the RTC. The pa-
rameters to enter are:
▪ dd: day of the month
▪ mm: month
▪ yyyy: year
▪ hh: hours
▪ mn: minutes
▪ ss: seconds
▪ tz: time zone; the minutes of devi-
ation from UTC must be entered. If
you are located east of Greenwich,
the value will be positive. Otherwise
it will be negative. As a reference in
Italy when there is Standard Time,
the deviation is +60 minutes, when
it is Daylight Saving Time, it is +120
minutes. If you enter the time, set
UTC to 0.
Table 50
Document uncontrolled when printed
New Group Cycle (D92):
Notes
Notes