Tightening Torques - Grease -Adhesives & Sealants - Belt Tensioning; Pedal - Technogym Group Cycle D92 Technical Service Manual

New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
12. TIGHTENING TORQUES - GREASE
-ADHESIVES & SEALANTS - BELT
TENSIONING

12.1 PEDAL

1. Apply a few drops of Loctite 2701 on the pedal thread.
2. Tighten the pedal with a torque wrench set to 40Nm.
3. Loosen the pedal by approx. one full rotation.
4. Tighten the pedal again using the same torque.
WARNING: This procedure allows the thread and the contact surface between the pedal
crank and the pedal to settle when the pedal is first tightened, thus ensuring an accurate
and secure fit when tightened for the second time.
WARNING: the right pedal has RH thread (standard), the left pedal has LH thread.
Wait approximately one hour before using the bike. This allows the loctite to take effect and dry com-
pletely.
Document uncontrolled when printed
Figure 253
Page 207