Loosening Of The Flywheel Screws; Lack Of Precision In The Watt Values Shown On The Display - Technogym Group Cycle D92 Technical Service Manual

New Group Cycle (D92):
Technical Service Guide - Rev. 5.1

6.3.5 LOOSENING OF THE FLYWHEEL SCREWS

If problems are found related to the loosening of the flywheel screws: reassemble the screws (15),
applying Loctite 243 on them and tightening them with a torque equal to 5 Nm (3.69 lbf-ft).
6.3.6 LACK OF PRECISION IN THE WATT VALUES SHOWN ON
THE DISPLAY
If the customer complains about 'Lack of precision in the Watt values shown on the display' follow
the below steps:
1-On the Knob: check the alignment between the hole and the tooth;
ALIGNMENT BETWEEN THE HOLE AND THE TOOTH OF THE KNOB")
2-Execute the mechanical product regulation through the correct template; (
THE CALIBRATION TEMPLATE" and "6.5.3 MECHANICAL REGULATION OF THE BRAKE
POSITION")
In this step of the procedure do not perform the calibration yet.
3-Take note of the Read Value and Database Value of Level L7 or L8, through the Equipment Soft-
ware Loader;
4-TEST_1: Test the Group Cycle:
_Make two complete turns of the knob;
_Execute an exercise at 80rpm;
_Take note of the Watts shown on the console;
5-Execute the soft calibration;("6.5.4 SOFT CALIBRATION OF THE BRAKE")
6- Take note of the Read Value and Database Value of Level L7 or L8, through the Equipment Soft-
ware Loader;
7-TEST_2: Test the Group Cycle:
Document uncontrolled when printed
15
Figure 15 - Detailed view of the flywheel screws (15)
14
("6.5.1 CHECKING THE
"6.5.2 CHECKING
Page 49