Software Upgrade For The New Wi-Fi / Ant+ Console - Technogym Group Cycle D92 Technical Service Manual

• Open the "console_wifi" sub-folder.
• Drag the fw file for the console (WFW----BA---versione.bin) to the equipment folder.
If you incorrectly try to load the SW for the new console in the old console, an error message will
appear and it will not be possible to load the SW.
• Wait for the file to copy (approx. 10 seconds);
• Disconnect the MINI USB cable from the console, the console will turn off after a few sec-
onds.
For the New Group Cycle Connect version, repeat the operations described above and
install the fw file for the wi-fi board (WFW----CA---versione.bin).
• When the SW update is complete, put the protective cover back on the console's MINI USB
connector.
• Put the console back on the bike.
7.2 SOFTWARE UPGRADE FOR THE NEW WI-FI /
ANT+ CONSOLE
The SW upgrade for the new WI-FI / ANT+ console can take place in two modes:
• remotely, via Asset;
• locally, via the procedure described below:
Remove the console as described in "11.1 Removing the console".
1. Starting situation:
• PC (laptop) switched on;
• USB-MINI USB Cable.
2. Procedure:
• Connect the MINI USB cable to the console and the USB socket to your PC (the console buttons
will light up).
• Press the PLAY/PAUSE button on the console within five seconds while the equipment is resetting
(the buttons on the console will blink slowly).
• An AUTOPLAY pop-up will appear on the PC for a USB flash drive called "FSL LOADER".
Page 84
New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
Document uncontrolled when printed