Technogym Group Cycle D92 Technical Service Manual page 140

2
Figure 119
Page 140
3
Technical Service Guide - Rev. 5.1
4. Screw the pedal (2) on the pedal crank (3)
using the special wrench provided.
WARNING: tighten the pedal with a
torque wrench set to 40Nm (29.5 lbf-ft).
5. Loosen the pedal by approx. one full ro-
tation.
6. Tighten the pedal again using the same
torque.
WARNING: This procedure allows the
thread and the contact surface between
the pedal crank and the pedal to settle
when the pedal is first tightened, thus
ensuring an accurate and secure fit
when tightened for the second time.
WARNING: the right pedal has RH
thread (standard), the left pedal has LH
thread.
Wait approximately one hour before using
the bike. This allows the loctite to take effect
and dry completely.
If grub screws are found during disassem-
bly, they do not need to be reinserted during
reassembly.
Document uncontrolled when printed
New Group Cycle (D92):