7.12. DISASSEMBLING THE BRAKE GROUP
Figure 7.12-1
Figure 7.12-2
Page 7.26
RECLINE EXCITE: Service & Maintenance Manual - rev. 1.3
Carry out the operations described in paragraphs
7.7.
"Disassembling
Disassembling
"Disassembling the brake winding".
1. Remove the snap ring a on the left side of the
machine.
Be careful with the various spacer rings
on the pulley shaft.
2. Remove the brake assembly
3. Place the brake assembly on a work bench.
Take particular care with the copper
disk, as it bends easily and may then
cause problems after reassembly, by
brushing against the winding block.
4. Back off the screws b using a 25-mm Torx
wrench.
5. Remove the copper disk.
Continued on following page →
the
guards",
the
belt"
and
7.9.
7.11.