Revision 4.0; Revision 4.1 - Technogym Group Cycle D92 Technical Service Manual

16.3 REVISION 4.0

New paragraph §6.1 PROCEDURE TO FOLLOW WHEN REPLACING COMPONENTS.
Changed paragraph §6.2 EXECUTABLE SW FOR DIAGNOSTICS WITH PC: Terminal settings.
1 - Added all the technical information regarding the new Wi-Fi / ANT+ console:
Changed paragraph §2.4 EQUIPMENT CODING: added device coding for New Group Cycle
(D92) with new Wi-Fi / ANT+ console.
Added note in §2.5 SERIAL NUMBER STRUCTURE.
New paragraph §3.1.5.2 NEW Wi-Fi /ANT+ CONSOLE: described the operating principles of the
new console.
Changed paragraph §12 SW UPGRADE: NEW Wi-Fi / ANT+ CONSOLE: remote upgrade via As-
set, or locally via the detailed procedure. New PC SYNCH folder structure.
New paragraph §6.3.1.2 BLE / ANT+ MODULE FIRMWARE VERSION: command info.
New paragraph §9 NEW Wi-Fi / ANT+ CONSOLE DETAILS.
2 - New information relative to the Group Cycle with the Watt Sensor ID board:
New paragraph §6.9 PROCEDURE FOR REPLACING THE WATT SENSOR ID BOARD ON
GROUP CYCLES FIT WITH REV. 2 ELECTRONICS.
New paragraph §6.10 PROCEDURE TO FOLLOW IF IT IS NECESSARY TO REMOVE THE PLATE
ON WHICH THE WATT SENSOR ID IS FIXED.
Changed paragraph §10.5.3 REMOVING THE FLYWHEEL, TRANSMISSION BELT AND GEN-
ERATOR BELT: indicated the procedure to follow for removing the flywheel in the case of a Group
Cycle with a Watt Sensor ID board.

16.4 REVISION 4.1

New paragraph §6.3.5: CONFIGURING THE DATE AND TIME
New paragraph §6.5: PROCEDURE FOR READING AND SETTING THE GEAR RATIO (GENER-
ATOR) ON THE WATT SENSOR BOARD
New paragraph §6.6: PROCEDURE FOR SETTING THE DATE AND TIME
New troubleshooting paragraph §6.8.3: USER NOT ABLE TO LOGIN / LOGIN ICON FLASHING
BUT Wi-Fi SET CORRECTLY
New troubleshooting paragraph §6.8.4: AFTER REPLACING THE WATT SENSOR BOARD, THE
CONSOLE DOES NOT TURN ON /THE RPM VALUES SHOWN ON THE DISPLAY ARE TOO
HIGH
Updated paragraph §6.1 PROCEDURE TO FOLLOW WHEN REPLACING COMPONENTS: up-
dated the procedure when replacing the WATT SENSOR.
Page 228
New Group Cycle (D92):
Technical Service Guide - Rev. 5.1
Document uncontrolled when printed