Dismantling The Belt And Belt-Tensioner - Technogym FORMA LINE BIKE FORMA DDC5 Series Technical Assistance Manual

7.10. DISMANTLING THE BELT AND BELT-TENSIONER

Figure 7.10-1
Figure 7.10-2
Figure 7.10-3
Page 7.26
Forma Line BIKE FORMA (DDC5): Technical Assistance manual - rev. 1.1
Carry out the operations in the paragraph: 7.1.
"IMPORTANT NOTE ON DISMANTLING" and
7.7. "Dismantling the guard".
1. Make a mark on the initial position.
2. Unhook the spring from the selector.
3. Remove the belt.
4. Remove the snap ring (a) the underlying
washer.
5. Remove the belt-tensioner (b).
6. Remove the pin (c) using a 6mm Allen
wrench.
To re-assemble the fitting, follow the above
operations in reverse and pay attention to the
WARNING:: During
tighten the pin (a) using a torque
wrench set at 10Nm.
During re-fitting,
LOCTITE 270 on the threaded side
of the pin (c) and grease the part in
contact with the belt-tensioner, using
MOLYCOTE W2 grease.
following notes:
Continues on the next page...
re-assembly,
place some