Configuring The Machine; Changing The Settings On The Display Panel; Language Used; Measurement System - Technogym BIKE XT Service Maintenance Manual

BIKE XT: Service & Maintenance manual - rev. 2.0

9. CONFIGURING THE MACHINE

Starting from the release 3.0 of the SW, it is possible to set some configuration parameters of the
machine.
Not all CPU boards are compatible with SW release 3.0. Therefore, if after replacing the
EPROM with the new one, the machine doesn't start up, it means that in order to
upgrade the machine, also the CPU board must be replaced.

9.1. CHANGING THE SETTINGS ON THE DISPLAY PANEL

To change the settings of the machine, when the equipment is in the standby mode, press numeric
keys 314 at the same time. The following will appear on the LED matrix:
Now, use the numeric keys to enter 2406 (the password) and press ENTER to confirm. At this
point, the setting procedure will show on the LED matrix the actual settings.
9.1.1. L
ANGUAGE USED
When a language is chosen from the list of languages available, all the messages on the display are
automatically shown in the chosen language. To change the current setting, when the language
actually in use will scroll on the LED matrix, press the proper numeric key (from 1 to 6) to choose
the desired language, as for the following table:
and press ENTER to confirm your choice.
9.1.2. M
EASUREMENT SYSTEM
Either the EUROPEAN (Kg and Km) or the AMERICAN (pounds and miles) measurement system
can be chosen. To change the current setting, when the measurement system is actually in use will
scroll on the LED matrix, press the proper numeric key (1 or 2) to choose the desired measurement
system, as for the following table:
PASSWORD = 0
number key language
1 ITALIANO
2 USA ENGLISH
3 UK ENGLISH
4 DEUTSCH
5 FRANCAIS
6 NEDERLANDS
number key

measurement system

1 EUR = EUROPEAN
2 USA = AMERICAN
Page 9.1