Power Source Inspection; Workstation Connections Inspection - Beckman Coulter CytoFLEX Series Instructions For Use Manual

6
Verify that all sheath fluid tubing, waste tubing, and sensor cables are properly connected, as
shown in the figure:
1. Waste level sensor connector. Connects to the waste liquid sensor cable.
2. Flow cell waste out. Connects to the flow cell waste tubing.
3. Sheath fluid level sensor connector. Connects to the sheath fluid sensor cable.
4. Waste out. Connects to the waste liquid tubing.
5. Sheath return. Connects to the sheath fluid tubing.
6. Sheath fluid in. Connects to the sheath fluid tubing.

Power Source Inspection

Check the power cable located below the power switch on the back of the Cytometer, and verify it is
securely connected to both the Cytometer and the power source.

Workstation Connections Inspection

Check that the monitor, mouse, keyboard, and the Cytometer are properly connected to the
computer. Refer to
B49006AH
b c
e
f
Figure 1.17.
d
g
Daily Startup 3
Pre-Startup Inspection
3-5