Switching the Sample Probe from the Plate Loader to the Single Tube Sample Station [With Sample Injection Mode Control Knob]
2
Turn the switch module knob to the left (counterclockwise) until the flat side of knob is
perpendicular to the front panel and the T is facing you. Ensure that the knob is turned as far
as it will go.
The system is now ready for use in either the Semi-Automatic or manual sample injection mode.
NOTE
If you do not see any events upon running an acquisition:
1. Select
2. Ensure that the switch module knob is turned as far as it will go.
3. Rerun the acquisition.
4. If the problem persists,
B49006AH
to stop the acquisition.
contact
us.
Sample Injection Mode Control Kit
C
C-5