Beckman Coulter CytoFLEX Series Instructions For Use Manual page 258

Data Review
Setting the Plots and Statistics
3
New plots can be created according to need. After selecting the test tubes requiring analysis, use
the plotting control buttons at the top of the screen to create a new plot.
NOTE
Each graph in the Analysis screen may correspond to different data. Pay special attention to each
plot's heading to avoid mistakes during analysis.
4
Use the sample selection controls in the graphics controls toolbar at the top of the page (see
Figure 2.1) to change the data displayed in a plot.
a. Select the plot requiring a change to the data displayed. By pressing and holding the Ctrl
key while selecting plots, you can select several plots at one time.
b. Select one of the two triangular sample selection buttons (
the previous sample and the next sample, or select
7-4
or ) to choose between
to specify which data to display.
B49006AH