6,0Xx.4X Errors - X-Axis Fault; 6,0Xx.6X Errors - Program Faults - Xerox PHASER 8500 Service Manual

Error Messages and Codes

6,0XX.4x Errors - X-Axis Fault

6,0XX.6x Errors - Program Faults

3-14
6,000.41: An X-Axis Motor current error occurred.
Troubleshooting Procedure for X-Axis Motor
Step Questions and Actions
1 1. Inspect the Printhead power cable and
heater wiring.
2. Verify the Printhead travels smoothly
from left to right.
3. Ensure the Printhead does not bind due to
ink spills.
Is Printhead movement restricted?
2 Clear the obstruction restricting Printhead
movement.
Did this correct the problem?
Inspect the X-Axis Motor harness.
3
Is the wiring damaged?
Use Service Diagnostics to test the X-Axis
4
drive.
Did the test fail?
6,001.64: The X-Axis task received an unexpected message.
6,002.65: Attempt to home the X-Axis from a state where homing is not
allowed.
6,008.62: Attempt to use the X-Axis drive without initializing it.
6,011.65: Attempt to service the X-Axis while not in the appropriate state.
6,013.67: Unknown X-Axis program fault.
6,017.62: An attempt was made to drive the X-Axis using the wrong server.
6,018.63: An attempt was made to move with the X-Axis uninitialized.
6,019.64: An attempt was made to move the X-Axis from a homeless state.
6,023.68: Could not allocate memory for X-Axis home parameters.
6,025.66: An attempt was made to home with the X-Axis uninitialized.
6,032.68: Could not find a solution to the described home motion profile.
6,033.60: Could not allocate memory for X-Axis move parameters.
a. Reset NVRAM, and then retest.
b. Ensure ground integrity for the printer (see "Ensuring Ground
Integrity" on page 4-65).
Phaser 8400/8500/8550/8560 Color Printer Service Manual
Yes No
Go to Step 2. Go to Step 3.
Complete. Go to Step 3.
Replace the Go to Step 4.
harness.
Replace the X- Replace the
Axis Motor. Electronics
Module.