Reel Fore-Aft Position; Adjusting Reel Fore-Aft Position; Repositioning Fore-Aft Cylinder On Single Reel - MacDon D65 Operator's Manual

4.7.9 Reel Fore-Aft Position

Reel position has been found to be a critical factor in achieving good results in adverse conditions. The reel
position is factory-set for average straight standing crop and can be adjusted forward and backward for different
crop conditions.
A decal is provided on the reel right support arm for
identifying a preferred position. The back edge of the reel
cam disc is the gauge indicator.
Refer to Section 4.6.1 Header Settings, page 46
recommended reel positions in specific crops and
crop conditions.

Adjusting Reel Fore-Aft Position

To adjust the reel fore-aft position, follow these steps:
1. Select FORE-AFT mode on the selector switch in the cab.
2. Operate the hydraulics to move the reel to the desired position, again using the gauge as a reference.
3. Check reel clearance to cutterbar after making changes to cam setting. Refer to
• Section 6.8.1 Reel Clearance to Cutterbar, page 196
• Section 6.8.2 Reel Frown, page 199
Operating with the reel too far forward can cause the fingers to contact the ground before the cutterbar.
Lower the skid shoes or adjust header tilt as required when operating with the reel in this position,
otherwise, damage to the fingers will occur.

Repositioning Fore-Aft Cylinder on Single Reel

The reel can be moved approximately 9 in. (227 mm) further aft by repositioning the cylinders on the reel arms.
This may be desirable when straight-combining canola.
WARNING
Stop windrower engine and remove key before making adjustments to machine. A child or even a pet
could engage the drive.
169594
OPERATION
for
Figure 4.32: Decal
and
for measurements and adjustment procedures.
IMPORTANT
60
Rev. C