Replacing Double-Reel U-Joint; Removing Double-Reel U-Joint; Installing Double-Reel U-Joint - MacDon D65 Operator's Manual

5.9.4 Replacing Double-Reel U-Joint

The double-reel drive U-joint allows each reel to move independently from the other.
Lubricate the U-joint according to specifications. For instructions, refer to
Replace the U-joint if it is severely worn or damaged. For instructions, refer to

Removing Double-Reel U-Joint

If the double-reel U-joint is worn or damaged, it will need to be replaced.
1. Shut down the engine, and remove the key from the ignition.
2. Remove the drive cover. For instructions, refer to
3. Support the inboard end of the right reel with a front end
loader and nylon slings (A) (or equivalent lifting device).
IMPORTANT:
Avoid damaging or denting the center tube by supporting
the reel as close to the cam end disc as possible.
4. Remove six bolts (A) attaching U-joint flange (B) to driven
sprocket (C).
5. Remove the U-joint.
NOTE:
It may be necessary to move the right reel sideways for the
U-joint to clear the tube.

Installing Double-Reel U-Joint

Once the old U-joint has been removed, a new one can be installed.
NOTE:
It may be necessary to move the right reel sideways for the U-joint to clear the reel tube.
214327
MAINTENANCE AND SERVICING
Removing Reel Drive Cover, page
Figure 5.225: Supporting Reel
Figure 5.226: U-Joint
234
5.3.6 Lubrication, page 125.
Removing Double-Reel U-Joint, page
227.
A
C
A
234.
B
Revision B