Spanning-Tree Disable - Cisco SPS2024 Reference Manual

Spanning Tree Commands

spanning-tree disable

spanning-tree disable
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
Example
The following example configures spanning tree priority to 12288.
Console(config)# spanning-tree priority 12288
The spanning-tree disable Interface Configuration mode command disables
spanning tree on a specific port. Use the no form of this command to enable
spanning tree on a port.
Syntax
spanning-tree disable
no spanning-tree disable
Default Configuration
Spanning tree is enabled on all ports.
Command Modes
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example disables spanning-tree on Ethernet port e5.
Console(config)# interface ethernet e5
Console(config-if)# spanning-tree disable
28
371