Dot1X Port-Control - Cisco SPS2024 Reference Manual

802.1x Commands

dot1x port-control

dot1x port-control
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
User Guidelines
There are no user guidelines for this command.
Example
The following example enables 802. 1 x globally.
Console(config)# dot1x system-auth-control
The dot1x port-control Interface Configuration mode command enables manually
controlling the authorization state of the port. Use the no form of this command to
restore the default configuration.
Syntax
dot1x port-control {auto | force-authorized | force-unauthorized}
no dot1x port-control
Parameters
•
auto — Enables 802. 1 x authentication on the interface and causes the port
to transition to the authorized or unauthorized state based on the 802. 1 x
authentication exchange between the port and the client.
•
force-authorized — Disables 802. 1 x authentication on the interface and
causes the port to transition to the authorized state without any
authentication exchange required. The port resends and receives normal
traffic without 802. 1 x-based authentication of the client.
•
force-unauthorized — Denies all access through this interface by forcing
the port to transition to the unauthorized state and ignoring all attempts by
the client to authenticate. The device cannot provide authentication
services to the client through the interface.
36
518