Dot1X Timeout Server-Timeout - Cisco SPS2024 Reference Manual

802.1x Commands

dot1x timeout server-timeout

dot1x timeout server-timeout
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
The dot1x timeout server-timeout Interface Configuration mode command sets the
time that the device waits for a response from the authentication server. Use the
no form of this command to restore the default configuration.
Syntax
dot1x timeout server-timeout
no dot1x timeout server-timeout
Parameters
•
seconds —
Time in seconds that the device waits for a response from the
authentication server. (Range: 1-65535 seconds)
Default Configuration
The timeout period is 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The actual timeout can be determined by comparing the dot1x timeout server-
timeout value and the result of multiplying the radius-server retransmit value with
the radius-server timeout value and selecting the lower of the two values.
Example
The following example sets the time for the retransmission of packets to the
authentication server to 3600 seconds.
Console(config)# interface ethernet e16
Console(config-if)# dot1x timeout server-timeout 3600
seconds
36
527