Trust - Cisco SPS2024 Reference Manual

QoS Commands

trust

trust
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
Policy Map policy2
class class 2
police 96000 4800 exceed-action drop
class class3
police 124000 96000 exceed-action policed-dscp-transmit
The trust Policy-Map Class Configuration mode command configures the trust
state, which selects the value QoS uses as the source of internal DSCP value. Use
no trust in order to return to the default trust state.
Syntax
trust [cos | dscp | cos-dscp]
no trust
Parameters
•
cos—QoS set the queue according to CoS to Queue Map.
•
dscp—QoS derives the internal DSCP value by using the DSCP value from
the ingress packet. This is the default when no keyword is specified.
•
cos-dscp—If the packet is IP then acts as dscp, otherwise acts as cos.
Default Configuration
Not trusted
Command Mode
Policy-map Class Configuration mode
23
277