Chapter 32: Tacacs+ Commands; Tacacs-Server Host - Cisco SPS2024 Reference Manual

TACACS+ Commands

tacacs-server host

SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
The tacacs-server host Global Configuration mode command specifies a
TACACS+ host. Use the no form of the command to delete the specified name or
address.
Syntax
ip-address
tacacs-server host {
timeout
[timeout ] [key
no tacacs-server host {
Parameters
•
ip-address
— IP address of the TACACS+ server.
•
hostname
— Host name of the TACACS+ server. (Range: 1-158 characters)
•
single-connection — Indicates a single-connection. Rather than have the
device open and close a TCP connection to the daemon each time it must
communicate, the single-connection option maintains a single open
connection between the device and the daemon.
•
port-number
— Specifies a server port number. The host is not used for
authentication if the port number is set to 0. (Range: 0-65535)
•
timeout
— Specifies the timeout value in seconds. (Range: 1-30)
•
key-string — Specifies the authentication and encryption key for all
TACACS+ communications between the device and the TACACS+ server.
This key must match the encryption used on the TACACS+ daemon. To
specify an empty string, enter "". (Range: 0-128 characters)
hostname
| } [single-connection] [port
key-string source
] [source
ip-address hostname
|
32
] [priority priority]
}
port-number
]
456