Garp Timer - Cisco SPS2024 Reference Manual

GVRP Commands

garp timer

garp timer
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
Example
The following example enables GVRP on Ethernet port e6.
Console(config)# interface ethernet e6
Console(config-if)# gvrp enable
The garp timer Interface Configuration (Ethernet, Port channel) mode command
adjusts the values of the join, leave and leaveall timers of GARP applications. Use
the no form of this command to restore the default configuration.
Syntax
garp timer {join | leave | leaveall}
no garp timer
Parameters
•
{join | leave | leaveall} — Indicates the type of timer.
•
timer_value
— Timer values in milliseconds in multiples of 10. (Range: 10-
2147483640)
Default Configuration
Following are the default timer values:
•
Join timer — 200 milliseconds
•
Leave timer — 600 milliseconds
•
Leaveall timer — 10000 milliseconds
Command Mode
Interface Configuration (Ethernet, port-channel) mode
timer_value
13
184