Clock Commands
sntp server
sntp server
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
The sntp server Global Configuration mode command configures the device to
use the Simple Network Time Protocol (SNTP) to request and accept SNTP traffic
from a specified server. Use the no form of this command to remove a server from
the list of SNTP servers.
Syntax
ip-address
sntp server {
no sntp server host
Parameters
•
ip-address —
•
hostname
— Hostname of the server. (Range: 1-158 characters; Maximum
label size: 63)
•
poll — Enable polling.
•
keyid
— Authentication key to use when sending packets to this peer.
(Range:1-4294967295)
Default Configuration
No servers are defined.
Command Mode
Global Configuration mode
User Guidelines
Up to 8 SNTP servers can be defined.
Use the sntp unicast client enable Global Configuration mode command to enable
predefined Unicast clients globally.
hostname
|
} [oll] [key
IP address of the server.
keyid
]
6
116