Radius-Server Timeout - Cisco SPS2024 Reference Manual

RADIUS Commands

radius-server timeout

radius-server timeout
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
The radius-server timeout Global Configuration mode command sets the interval
during which the device waits for a server host to reply. Use the no form of this
command to restore the default configuration.
Syntax
radius-server timeout
no radius-server timeout
Parameters
•
timeout
— Specifies the timeout value in seconds. (Range: 1-30)
Default Configuration
The timeout value is 3 seconds.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the timeout interval on all RADIUS servers to 5
seconds.
Console(config)# radius-server timeout 5
timeout
24
311