Cisco SPS2024 Reference Manual page 126

Configuration and Image File Commands
copy
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
The following table describes copy characters:
Character
!
.
Copying an Image File from a Server to Flash Memory — To copy an image file
from a server to flash memory, use the copy
Copying a Boot File from a Server to Flash Memory — To copy a boot file from a
server to flash memory, enter the copy
Copying a Configuration File from a Server to the Running Configuration File — To
load a configuration file from a network server to the running configuration file of
the device, enter the copy
the loaded configuration file are added to those in the running configuration file as
if the commands were typed in the command-line interface (CLI). Thus, the
resulting configuration file is a combination of the previous running configuration
and the loaded configuration files with the loaded configuration file taking
precedence.
Copying a Configuration File from a Server to the Startup Configuration — To copy
a configuration file from a network server to the startup configuration file of the
source-url
device, enter copy
replaced by the copied configuration file.
Storing the Running or Startup Configuration on a Server — Use the copy running-
destination-url
config
server using TFTP. Use the copy startup-config
the startup configuration file to a network server.
Saving the Running Configuration to the Startup Configuration — To copy the
running configuration to the startup configuration file, enter the copy running-
config startup-config command.
Description
For network transfers, indicates that the copy
process is taking place. Each exclamation
point indicates successful transfer of ten
packets (512 bytes each).
For network transfers, indicates that the copy
process timed out. Generally, many periods in
a row means that the copy process may fail.
source-url
source-url
running-config command. The commands in
startup-config. The startup configuration file is
command to copy the current configuration file to a network
source-url
image command.
boot command.
destination-url
command to copy
7
124