Sntp Broadcast Client Enable - Cisco SPS2024 Reference Manual

Clock Commands

sntp broadcast client enable

sntp broadcast client enable
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
Example
The following example sets the polling time for the SNTP client to 120 seconds.
Console(config)# sntp client poll timer 120
The sntp broadcast client enable Global Configuration mode command enables
Simple Network Time Protocol (SNTP) Broadcast clients. Use the no form of this
command to disable SNTP Broadcast clients.
Syntax
sntp broadcast client enable
no sntp broadcast client enable
Default Configuration
The SNTP Broadcast client is disabled.
Command Mode
Global Configuration mode
User Guidelines
Use the sntp client enable (Interface) Interface Configuration mode command to
enable the SNTP client on a specific interface.
Example
The following example enables the SNTP Broadcast clients.
Console(config)# sntp broadcast client enable
6
110