Show Bridge Multicast Address-Table Static - Cisco SPS2024 Reference Manual

Address Table Commands

show bridge multicast address-table static

NOTE
show bridge multicast address-table static
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
A Multicast MAC address maps to multiple IP addresses as shown above.
The show bridge multicast address-table static Privileged EXEC mode command
displays the statically configured Multicast addresses.
Syntax
show bridge multicast address-table static [vlan
address ip-multicast-address
|
[source ip-address ]
Parameters
•
vlan-id
— Indicates the VLAN ID. This has to be a valid VLAN ID value.
•
mac-multicast-address
•
ip-multicast-address
•
ip-address
— Source IP address.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
A MAC address can be displayed in IP format only if it is in the range
0100.5e00.0000 through 0100.5e7f.ffff.
]
— A valid MAC Multicast address.
— A valid IP Multicast address.
vlan-id mac-multicast-
] [address
5
94