Port Jumbo-Frame - Cisco SPS2024 Reference Manual

Ethernet Configuration Commands

port jumbo-frame

port jumbo-frame
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
There are no user guidelines for this command.
Example
In the following example back pressure is enabled on port 1.
Console(config)# interface ethernet 1
Console(config-if)# back-pressure
Use port jumbo-frame command to enable jumbo frames for the device. To disable
it, use the no form of this command.
Syntax
port jumbo-frame
no port jumbo-frame
Parameters
This command has no arguments or keywords.
Default Configuration
Off
Usage Guidelines
The command would be effective only after reset.
12
162