Spanning-Tree Priority - Cisco SPS2024 Reference Manual

Spanning Tree Commands

spanning-tree priority

spanning-tree priority
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
Example
The following example configures the spanning tree bridge maximum-age to 10
seconds.
Console(config)# spanning-tree max-age 10
The spanning-tree priority Global Configuration mode command configures the
spanning tree priority of the device. The priority value is used to determine which
bridge is elected as the root bridge. Use the no form of this command to restore
the default configuration.
Syntax
spanning-tree priority
no spanning-tree priority
Parameters
•
priority
— Priority of the bridge. (Range: 0-61440 in steps of 4096)
Default Configuration
The default bridge priority for IEEE Spanning Tree Protocol (STP) is 32768.
Command Modes
Global Configuration mode
User Guidelines
The bridge with the lowest priority is elected as the root bridge.
priority
28
370