Gvrp Vlan-Creation-Forbid - Cisco SPS2024 Reference Manual

GVRP Commands

gvrp vlan-creation-forbid

gvrp vlan-creation-forbid
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide
User Guidelines
The following relationship must be maintained between the timers:
Leave time must be greater than or equal to three times the join time.
Leave-all time must be greater than the leave time.
Set the same GARP timer values on all Layer 2-connected devices. If the GARP
timers are set differently on Layer 2-connected devices, the GARP application will
not operate successfully.
Example
The following example sets the leave timer for Ethernet port e6 to 900
milliseconds.
Console(config)# interface ethernet e6
Console(config-if)# garp timer leave 900
The gvrp vlan-creation-forbid Interface Configuration (Ethernet, port-channel)
mode command disables dynamic VLAN creation or modification. Use the no form
of this command to enable dynamic VLAN creation or modification.
Syntax
gvrp vlan-creation-forbid
no gvrp vlan-creation-forbid
Default Configuration
Dynamic VLAN creation or modification is enabled.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
13
185